As I wait for my parts to be recut (CNC calibration issue), I’ve been working on the outriggers. Ingredients: Cones from Parts Express, knobs from McMaster-Carr, some waterjet steel, and some inspiration from Bill S. These should take form shortly. We’ll see how close the real thing is to the render.… Continue Reading
Category Archives: 4TSE
![Outriggers [done]](https://www.baniels.com/wp-content/uploads/2011/03/IMG_6058-150x150-150x150.jpg)
Outriggers [done]
These turned out quite well. I had to get a little creative. The cones were already tapped for an m6 thread. I couldn’t find a knob that I liked in M6 – they were all a little smaller than I wanted. I bought knobs tapped for an M8 thread, and used JB Welb to epoxy in some… Continue Reading
Gluing #1
Every time I think I will finally have enough clamps, I find myself wanting 3 or 4 more. I glued the bracing to one of the side panels for each cabinet first. Today I clamped up the first of the rear panels. In addition to a few more clamps, I’d like another 3 or 4… Continue Reading
Weekend Progress
I suspect I should be wiring by the end of the week. Most of the woofer foam has been applied. I need to get my hands on the right router bit for flush mounting the port and the binding post plate, but that can happen later – actually I can’t route rabbet for the port… Continue Reading
Wiring
80% of the wiring is complete. I HOPE to be attaching the side panels this weekend. … … … Continue Reading
Wiring Complete
Well, mostly. I will have a couple connectors to do after I run the wires in through the mid chamber.… Continue Reading